newbas.blogg.se - Ic-7800 dual channel version

IC 7800 DUAL CHANNEL VERSION DRIVERS
IC 7800 DUAL CHANNEL VERSION DRIVER

Front panel transmit/receive level control.

Ultra low noise floor, below the noise floor from any current transceiver.

24-bit, high dynamic range, very low distortion analog inputs.

Supports most Elecraft, Icom, Kenwood, Ten-Tec, Yaesu and other radios.

Integrated menu driven (no jumpers) level converter for CI-V, FIF-232, IF-232, or RS-232 levels.

IC 7800 DUAL CHANNEL VERSION DRIVERS

USB Class compatibility (Audio & CDC), no drivers required for Windows 10, macOS and Linux.Real-Time audio input level monitoring on built-in display.Asynchronous data transfer, internal low phase noise LO: -145dBc/Hz High dynamic range: 100 dB typical, 95 dB minimum.

IC 7800 DUAL CHANNEL VERSION DRIVER

Standard USB Audio Class device – no custom driver required.

Complete "Computer ↔ Transceiver ↔ Amplifier" galvanic isolation.

Single USB connection to computer for power, data and audio<.

High dynamic range 24-bit audio circuits are derived from our flagship interface - micro KEYER III, preserving transceiver performance also for digital modes, otherwise limited by 16-bit USB audio sound card built-in the transceiver or by using some other interface. The DB15F system connector is fully compatible with previous microHAM interfaces: USB II, USB III, DK, and DK II and uses the same DB15 cables. CAT interface is jumper-free set up from the menu. The relay-free construction of DXP provides quiet operation based on an optoMOS part replacing the traditional output relay. DXP does not need our USB Device Router for operation.ĭXP™ is fully powered from a standard USB port while maintaining full galvanic isolation between computer and transceiver. This means, that drivers are already incorporated in all current major computer operating systems, no driver installation is necessary. DXP™ is the first microHAM interface entirely utilizing Standard USB Class Devices for its USB operation.